Universal Cone Filter
PERRIN 2-PIECE FOAM FILTER
This is a direct replacement for most Subaru PERRIN Performance intakes systems including the Big MAF intakes. It will also work on any intake system which accepts a 3.125” filter.
Two Piece Design
PERRIN Performance filters feature a unique two piece design allowing the user to remove the foam filter element for easy cleaning. Easily run the element under a faucet for cleaning and ring out by hand. Simply slip the foam sleeve back over the filter frame and your ready to go.
Please check the Inlet Inside Diameter (I.D.) of the filter are replacing as there are variations of intake design. This filter has a 3.125” I.D. Inlet.
Open Cell Foam Element
PERRIN foam filters are made of reticulated polyurethane foam which offers a minimal air restriction. The filter element is sprayed with a special oil that adheres to the foam making the poly matrix sticky to retain dirt. Foam filters do not block dirt, they grab it, suffering only minimal drops in air flow as they filter dirt, maintaining air flow levels when other filters would clog.
Clean and Protect
Remove months of oil and grime by simply spraying on this easy to use cleaner. Just let it sit on the filter element for a few moments and simply rise in the sink. Once your filter is dry, just spray on a fresh coat of oil and you are ready to go.
PERRIN Performance intake filter elements use open cell foam to capture dust and dirt. Washable and reusable, PERRIN foam filter elements can last the life of your vehicle. Foam filter elements offer superior performance with minimal airflow restriction and amazing dust holding capacity.
Protect your filter and intake from the most extreme environments.
Pre-filters are designed to deflect the damaging debris, which clogs air filters, compromising peak air-flow and horsepower. The PERRIN Performance Pre-Filters down to .005 Microns
Extend Service Intervals
The PERRIN Performance Pre-filter extends the time between servicing intervals reducing costs and increasing convenience.
The Pre-filter is constructed with a proprietary polyester mesh with uniform micron openings. The mesh is UV resistant, and can withstand heat up to 450 degrees. The material is puncture resistant and has elasticity characteristics allowing the threads to return to the original position in the event the threads have been impacted or shifted.